All parts of small mixer equipment must be rechecked after installation, and its manufacturing quality should meet the requirements of drawings or specifications.

　　各種密封件安裝之后，無潤滑油泄漏。

　　After installation of various seals, no lubricating oil leakage.

　　除無選擇要求之外，攪拌軸的旋轉方向應與圖之中所示方向一致，不得反轉。

　　In addition to no selection requirements, the rotation direction of the stirring shaft should be consistent with the direction shown in the drawing, and should not be reversed.

　　安裝之后小型攪拌機的攪拌軸上端擺動允許偏差符合要求。

　　After installation, the allowable deviation of the upper end of the mixing shaft of the small mixer meets the requirements.

　　安裝之后，小型攪拌機設備必須經過以水為介質的操作和攪拌工質的帶負荷試運行。

　　After installation, the small mixer equipment must undergo a water-based operation and a load test of the mixing medium.

　　試運行前夕，設備應穩定運行。無異常振動和噪音；當以水為介質時，運行時間不少于2小時，負載運行時，小型攪拌機應為4小時，其余時間不少于24小時。

　　Before trial run, the equipment should run stably. No abnormal vibration and noise; When water is used as the medium, the running time should not be less than 2 hours, when the load is running, the small mixer should be 4 hours, the rest of the time should not be less than 24 hours.

　　試運行和正常運行前夕小型攪拌機不允許空載運行。

　　Idle operation of small mixer is not allowed before trial run and normal operation.

　　在正常工作條件之下，軸承的溫升不得大于40℃。最高溫度不得超過80℃。

　　Under normal working conditions, the temperature rise of the bearing shall not be greater than 40℃. The maximum temperature shall not exceed 80℃.

　　如果要長期使用設備，日常維護也很重要。 常見的維護保養一般有以下幾點：

　　Routine maintenance is also important if the equipment is to be used for a long time. The common maintenance is as follows:

　　使用良好的攪拌設備需要及時清理； 日常維護或長期不使用時需要切斷電源； 應定期檢查機油箱內的油量是否充足，不足應及時補充； 對帶輪的大容量、大功率電機，應定期檢查磨損程度； 如有電氣故障，應聯系專業人員進行檢修。

　　The use of good mixing equipment needs to be cleaned in time; The power supply needs to be cut off for routine maintenance or long-term non-use. Should regularly check whether the amount of oil in the oil box is sufficient, insufficient should be supplemented in time; For large capacity and high power motor with wheel, wear degree should be checked regularly; If there is an electrical fault, contact professional personnel for repair.

　　還要定期檢查項目。定期檢查小型攪拌機各減速箱及各光滑部位光滑油能否足夠；要定期檢查攪拌機的發動拌和電動機，兩根半軸旋轉方向應與標牌指示方向共同，如方向不對，應改動電源接線。

　　Check items regularly. Check regularly whether the smooth oil of each reducer and each smooth part of the small mixer is enough; The rotation direction of the two half shafts should be the same as the direction indicated on the label. If the direction is wrong, the power supply wiring should be changed.

　　還想了解小型攪拌機設備的更多內容，可以來http://www.www.boy7up.cn網站咨詢！