自上料攪拌車的使用與保養是息息相關的，要懂得巧妙地使用自上料攪拌車才能省去很多不必要的麻煩。接下來一起來看看駕駛時的注意事宜，了解的知識越深，對于自上料攪拌車的使用保養就會越輕松。

The use and maintenance of the self loading mixer are closely related. You should know how to use the self loading mixer skillfully to save a lot of unnecessary trouble. Next, let's take a look at the precautions when driving. The deeper you know, the easier it will be to use and maintain the self feeding mixer.

1、自上料攪拌車作業設備連續工作時刻不該超越8h。運送混凝土的容量，質量及塌落度應契合混凝土行業標準和要求。

1. The continuous working time of the operation equipment from the charging mixer shall not exceed 8h. The capacity, quality and slump of delivered concrete shall conform to the standards and requirements of the concrete industry.

2、自上料攪拌車水箱的水量要經常加滿，以備急用。水箱加水前，有必要翻開放氣閥把箱內空氣放掉；沖刷時翻開氣閥，沖刷完畢或許停用時應將水罐內氣體放掉。冬天停放時，水箱和供水體系里，不得有剩下水，避免凍裂。注意：水箱僅在供水時加壓,不要帶著加壓水箱在公路上行進。

2. The water tank of the self feeding mixer shall be filled frequently for emergency use. Before the water tank is filled with water, it is necessary to turn over the air valve to drain the air in the tank; Open the air valve when flushing, and discharge the air in the water tank after flushing or when it is out of service. When parking in winter, there shall be no water left in the water tank and water supply system to avoid frost cracking. Note: The water tank is pressurized only when supplying water. Do not carry the pressurized water tank on the road.

3、自上料攪拌車在混凝土運送過程中罐體制止停轉，避免形成混凝土的凝聚，停轉重啟時會形成對液壓體系、減速機的沖擊，致使液壓泵和馬達的損壞。

3. Stop the stop of the tank of the self feeding mixer during the concrete delivery process to avoid the formation of concrete condensation. The stop and restart will cause impact on the hydraulic system and reducer, causing damage to the hydraulic pump and motor.

4、滿載混凝土正轉，如要回轉，有必要操作手柄使正轉停穩后，再操作手柄回轉。禁止正轉過程中操作手柄使其回轉。

4. Full load concrete rotates forward. If it is necessary to rotate, it is necessary to operate the handle to make the forward rotation stop stably, and then operate the handle to rotate. Do not operate the handle to rotate it during forward rotation.

5、自上料攪拌車卸料時，如發現水分蒸騰，塌落度偏低不能滿意用戶要求時，可適當向筒內加水，然后以10—14r/min的速度旋轉30轉后卸料，使混凝土充分拌和。

5. When discharging from the charging mixer truck, if it is found that the water transpiration and slump are too low to meet the user's requirements, water can be properly added into the cylinder, and then the concrete can be fully mixed after 30 revolutions at the speed of 10-14r/min.

6、拌和車在空載運轉過程中，拌和筒不得停轉避免波動時形成滾道和托輪部分磕碰，致使托輪和滾道的反常損壞。

6. During the no-load operation of the mixing truck, the mixing drum shall not stop to avoid the roller path and roller path from colliding with each other in case of fluctuation, which may cause abnormal damage to the roller and roller path.

自上料攪拌車在公路上行駛時，加長溜槽有必要放置在卸料溜槽支架上并用掛鉤掛牢，不允許掛在主排料溜槽上運轉；主排料溜槽要旋轉到固定方位，拉下定位手柄，用鎖緊手柄將繃簧變幅機構鎖止，避免由于不固定而搖擺，形成傷人事端和影響其它車輛運轉能。更多相關內容就來我們網站http://www.www.boy7up.cn進行咨詢吧！

When the self loading mixer is driving on the road, it is necessary to place the extended chute on the discharge chute bracket and hang it firmly with hooks. It is not allowed to hang it on the main discharge chute for operation; The main discharge chute shall be rotated to a fixed position, the positioning handle shall be pulled down, and the tension spring luffing mechanism shall be locked with the locking handle to avoid swinging due to non fixation, which may cause personal injury and affect the operation of other vehicles. More relevant content will come to our website http://www.www.boy7up.cn Consult!