如何降低自上料攪拌車的油耗以及使用中要注意的問題呢？下面小編為您整理了內容點，了解好才能更好更安全的進行操作施工。

How to reduce the fuel consumption of self loading mixer truck and the problems that should be paid attention to in use? The following editor has sorted out the content points for you. Only with a good understanding can we carry out the operation and construction better and more safely.

降低攪拌車油耗

Reduce fuel consumption of mixer truck

在行駛中或啟動時發現自上料攪拌車車輪有異常響聲，要及時檢查軸承及剎車系統是否有故障。如果車輪運轉不正常，就會影響車速，從而使油耗加大。離合器打滑會使動員機的轉速降低。當您在急加速時發現動員機轉速表增加很快，但車速增加卻很慢，這時可以鑒定是離合器打滑了。

If abnormal noise is found on the wheels of the self loading mixer truck during driving or starting, it is necessary to timely check whether the bearing and braking system are faulty. If the wheels don't work properly, it will affect the speed of the vehicle and increase the fuel consumption. Clutch slip will reduce the speed of the mobilizer. When you accelerate rapidly, you find that the speedometer of the mobilizer increases rapidly, but the speed increases slowly. At this time, you can identify that the clutch is slipping.

自上料攪拌車火花塞使用的時間太長，也會出現油耗加大的現象。因為火花塞損壞會使焚燒的能量下降，使攪拌車提速減慢，導致柴油耗損明顯增加，只要更換火花塞就好了。

Since the spark plug of the charging mixer has been used for too long, the fuel consumption will also increase. Because the damage of spark plug will reduce the energy of incineration, slow down the speed-up of mixer truck, and lead to a significant increase in diesel consumption. As long as the spark plug is replaced.

當自上料攪拌車的溫控開關和節溫器損壞時，會呈現油耗增加的現象。因為溫控開關和節溫器損壞會使水溫低落，化油器不能正常工作，導致攪拌車霧化不良，油耗量明顯增加。長時間行駛時，凡是會出現汽缸壓力不符的現象，這時油耗也會明顯增加。同時如果出現這種情況，那么就需要大修了。

When the temperature control switch and thermostat of the self loading mixer are damaged, the fuel consumption will increase. Because the temperature control switch and thermostat are damaged, the water temperature will be low, and the carburetor will not work normally, resulting in poor atomization of the mixer and significantly increased fuel consumption. When driving for a long time, the cylinder pressure will be inconsistent, and the fuel consumption will also increase significantly. At the same time, if this happens, it needs overhaul.

使用中要注意的問題

Problems needing attention in use

1、自上料攪拌車應停入在平地上，并將鏟斗平放地面。當發動機熄火后，需反復多次扳動工作裝置操縱手柄，確保各液壓缸處于無壓休息狀態。當自上料攪拌車只能停在坡道上時，要將輪胎墊牢。

1. The self loading mixer truck should stop on the flat ground and place the bucket flat on the ground. When the engine shuts down, it is necessary to pull the operating handle of the working device repeatedly to ensure that all hydraulic cylinders are in a pressure free rest state. When the self loading mixer can only stop on the ramp, the tires shall be firmly padded.

2、自上料攪拌車在停止工作后操作人員將各種手柄置于空擋或中間位置。

2. Since the loading mixer stops working, the operator will put various handles in neutral or middle positions.

3、先取走電鎖鑰匙，然后關閉電源總開關，后關閉門窗。

3. First remove the electric lock key, then turn off the main power switch, and then close the doors and windows.

4、自上料攪拌車嚴禁停在有明火或高溫地區，以防輪胎受熱爆炸，引起事故。

4. It is strictly forbidden to park the self loading mixer in the area with open fire or high temperature to prevent the tire from being heated and exploding, causing accidents.

5、利用組合閥或儲氣罐對輪胎進行充氣時，人不得站在自上料攪拌車輪胎的正面，以防爆炸傷人。

5. When using the combination valve or air tank to inflate the tire, people should not stand in the front of the self loading mixer tire to prevent explosion injury.

降低攪拌車油耗及使用中要注意的問題如上所講，您可以了解一番，更多信息獲取就來我們網站http://www.www.boy7up.cn吧！

Reduce the fuel consumption of the mixer truck and the problems that should be paid attention to in use. As mentioned above, you can learn more about it. For more information, please come to our website http://www.www.boy7up.cn Come on!