有時候小型攪拌車會出現一些小問題，這些下問題若是去修理廠修理不值當得，這時我們可以自己動手去進行修理，下面我們就來看看吧！

Sometimes small mixers will have some small problems. If these problems are not worth repairing in the repair shop, we can repair them ourselves. Let's take a look!

1、車門拉手松、鑰匙孔發澀：一把螺絲刀加一點潤滑油就可以搞定。

1. The door handle is loose and the key hole is jammed: a screwdriver with a little lubricating oil can fix it.

打開前車門，側面有一個塑料蓋，用螺絲刀旋開可以看到里面一個螺絲，松動一下，但不要完全擰開來，從外面把鎖芯拔出來，里面有一個門鎖拉線扣在把手上，調整一下拉線的松緊就可以解決這個問題。

When opening the front door, there is a plastic cover on the side. When you unscrew it with a screwdriver, you can see a screw inside. Loosen it, but don't unscrew it completely. Pull out the lock cylinder from the outside. There is a door lock cable inside which is buckled on the handle. Adjust the tension of the cable to solve this problem.

后備箱門的螺絲用密封條擋著，撥開密封條可以處理，鎖芯涂上潤滑油，就可以解決了。

The screws of the trunk door are blocked by the sealing strip, which can be handled by pulling open the sealing strip, and the lock cylinder can be solved by applying lubricating oil.

2、剩下的機油有妙用：積少成多。

2. The remaining oil has a wonderful effect: a little makes a lot.

每次保養，桶裝機油是用不完的，每次的剩余量蓋好蓋放在后備廂里就是了。三四次剩余的機油合在一起，也夠保養一次使用了。

Every time you maintain, you can't use up the barrel of oil. Just cover the remaining amount and put it in the rear compartment. The remaining oil after three or four times is enough for maintenance.

或者可以將每次換油剩下來用不了的那些機油都存起來，行駛4000公里后，從機油尺處抽出部分機油，加入剩下的機油，再開3000公里換油。

Or you can store the remaining unused oil after each oil change. After driving 4000 km, draw some oil from the oil dipstick, add the remaining oil, and then drive 3000 km to change the oil.

或者在下次保養時，放完機油后，先用少量剩余機油倒入缸內沖洗，排出殘留在缸底的油底，再添加新機油，這樣保養效果更好。

Or at the next maintenance, after the oil is discharged, pour a small amount of remaining oil into the cylinder for flushing, drain the remaining oil at the bottom of the cylinder, and then add new oil, so that the maintenance effect is better.

3、小動作可以延長車燈燈泡壽命

3. Small actions can prolong the life of lamp bulb

用酒精擦拭新燈泡，把燈泡上的指紋和油污去掉，這樣可以適度延長燈泡壽命。由于燈泡在點亮時工作溫度通常會很高，手印等留在燈泡表面的油脂會造成燈泡散熱不均勻，從而導致局部過熱使燈泡壽命縮短。

Wipe the new bulb with alcohol and remove the fingerprints and oil stains on the bulb, which can appropriately extend the life of the bulb. Because the working temperature of the bulb is usually very high when it is lit, the grease left on the surface of the bulb, such as fingerprints, will cause uneven heat dissipation of the bulb, which will lead to local overheating and shorten the life of the bulb.

汽車大燈的燈泡一般來說每行駛5萬公里或者2年左右，亮度效果就會減弱，這時需要更換燈泡。燈罩老化使燈光模糊，也會影響行車安全，因此燈罩一但出現老化也要立即更換。

Generally speaking, the brightness effect of the bulb of the car headlight will weaken every 50000 kilometers or about 2 years, and the bulb needs to be replaced. The aging of the lampshade will blur the light and affect the driving safety, so the lampshade should be replaced immediately once it is aging.

如果發現大燈高度車內調節不理想，可以將發動機蓋打開，大燈上方有一小孔，里面是內6角羅絲，用車上自備螺絲刀調整即可。

If you find that the height of the headlight is not adjusted well in the car, you can open the engine cover. There is a small hole above the headlight, inside which is an inner six-angle compass. You can adjust it with your own screwdriver.

上面說的這些小問題，大家可以根據上面這些方法來進行修理，就不需要自己再去修理廠了。當然您如果擔心還是去維修廠比較合適，更多相關內容就來我們網站http://www.www.boy7up.cn咨詢吧！

For the small problems mentioned above, you can repair them according to the above methods, so you don't need to go to the repair shop. Of course, if you are worried about it, it is better to go to the repair shop. For more information, please visit our website http://www.www.boy7up.cn Ask!