全自動攪拌車運行順利離不開各個系統的正常使用,其中攪拌系統起到了很大的作用,接下來我們就來講講它的五點維護。
The smooth operation of the automatic mixer can not be separated from the normal use of various systems, in which the mixing system plays a great role. Next, we will talk about its five points of maintenance.
1.攪拌筒運轉平穩,板、葉片、沒有松動現象,如有損壞及時更換;
1. The mixing drum shall operate stably, and the plates and blades shall be free from looseness. If they are damaged, they shall be replaced in time;
2.檢查葉片與襯板的間隙,過大易卡料損壞機器,一般情況下,當葉片與襯板的間隙達到10mm時應及時調整,間隙調整為6mm以下。這對延長襯板壽命十分有益。當襯板、葉片、刮板、攪拌臂等磨損至一定程度或者不能調整時,要及時更換;
2. Check the clearance between the blade and the lining plate. If it is too large, the machine will be damaged by jamming. Generally, when the clearance between the blade and the lining plate reaches 10mm, it should be adjusted in time, and the clearance should be adjusted to be less than 6mm. This is very useful for prolonging the service life of the lining plate. When the lining plate, blade, scraper and mixing arm are worn to a certain extent or cannot be adjusted, they shall be replaced in time;
3.清理攪拌筒體內外、卸料門、上料架和底盤上的積料,并用水沖洗干凈,當攪拌機內壁上的混凝土愈粘愈厚的時候,不但攪拌機的容積要減小,粘留混凝土的速度也會加快;
3. Clean the accumulated materials on the inside and outside of the mixing cylinder, the discharge gate, the loading rack and the chassis, and flush them with water. When the concrete on the inner wall of the mixer gets thicker and thicker, not only the volume of the mixer will be reduced, but also the speed of concrete adhesion will be accelerated;

4.砂石下料口會因為物料的粘結使下料口的斗門開關出現障礙,水泥的下料口會因為水氣的粘結越來越小,造成投料困難,因此要定期進行清理;
4. The opening and closing of the hopper door of the sand and gravel blanking opening will be blocked due to the bonding of materials, and the cement blanking opening will be difficult to feed due to the smaller and smaller bonding of moisture, so it should be cleaned regularly;
5.外加劑的投料管路可能因為沉淀和凝固使投料速度減慢或者造成堵塞,也要定期清理。
5. The feeding pipeline of the admixture may slow down or cause blockage due to sedimentation and solidification, so it should also be cleaned regularly.
That's all for the five points of maintenance related to the mixing system of the automatic mixer. If you have anything to know about it, please come to our website http://www.www.boy7up.cn Consult!