大家都知道
小型攪拌車有一個攪拌筒是專門進行材料攪拌的,所以可以說也是必不可少的一個重要部位,那么造成小型攪拌車的拌筒不能轉動是怎么個情況呢?下面小編為你講講。
As we all know, a small mixer has a mixing cylinder for mixing materials, so it can be said that it is also an essential part. What is the case that the mixing cylinder of a small mixer cannot rotate? The following is a small compilation for you.
一、液壓系統或發動機發生故障;
1、 Hydraulic system or engine failure;
(1)打開攪拌筒檢修孔蓋,旋松馬達上高壓軟管的管接頭,旋轉拌筒使拌筒檢修孔斜向下,將砼從攪拌筒檢修孔排出;
(1) Open the mixing drum manhole cover, unscrew the pipe joint of the high-pressure hose on the motor, rotate the mixing drum to make the mixing drum manhole downward, and discharge the concrete from the mixing drum manhole;
(2)將故障車的高壓膠管從馬達上卸下,把救援用的高壓膠管接上,另一端接在救援車的油泵上,并將應急用的回油管一端接在故障車的馬達泄油口,回油管另一端接在救援車的油泵回油口,利用救援車來控制故障車拌筒的旋轉,將砼排出。
(2) Remove the high-pressure rubber hose from the motor of the faulty vehicle, connect the high-pressure rubber hose for rescue, connect the other end to the oil pump of the rescue vehicle, connect one end of the emergency oil return pipe to the motor oil drain port of the faulty vehicle, and connect the other end of the oil return pipe to the oil return port of the oil pump of the rescue vehicle. Use the rescue vehicle to control the rotation of the mixing drum of the faulty vehicle and discharge the concrete.

我們經過現場的測試發現,在生產廠所有工具齊全的情況下,采用第2種方法大約需要1h,如在工地上時間可能會更長,因此建議采用1種方法排出砼。
Through field tests, we found that it takes about 1h to adopt the second method when all the tools in the factory are complete. If it takes longer on the site, it is recommended to adopt one method to discharge concrete.
二、馬達發生故障
2、 Motor failure
處理則較簡單,可把救援車的馬達卸下裝在故障車上,再將各個油管接好,啟動救援車即可將拌筒內的砼排出。對于小型攪拌車而言,發生故障時應及時判斷發生故障的原因,采取有效的措施將拌筒內的砼排出后再解決故障。
The treatment is relatively simple. The motor of the rescue truck can be unloaded and installed on the fault truck, and then each oil pipe can be connected. Start the rescue truck to discharge the concrete in the mixing drum. For small mixer trucks, the cause of failure shall be determined in time when failure occurs, and effective measures shall be taken to discharge the concrete in the mixing drum before troubleshooting.
The two conditions that cause the mixing drum of the small mixer to fail to rotate are explained above. If you have any questions or needs, please come to our website http://www.www.boy7up.cn Consult!