<address id="913f9"></address>

      <noframes id="913f9"><form id="913f9"><th id="913f9"></th></form>

      <address id="913f9"><address id="913f9"><nobr id="913f9"></nobr></address></address>
      <address id="913f9"><form id="913f9"><nobr id="913f9"></nobr></form></address>

      <address id="913f9"><dfn id="913f9"><listing id="913f9"></listing></dfn></address>
        <address id="913f9"><listing id="913f9"><meter id="913f9"></meter></listing></address>
        <noframes id="913f9"><form id="913f9"><nobr id="913f9"></nobr></form>

        <address id="913f9"></address>

        全國咨詢熱線

        400-879-1999

        點擊撥打服務熱線:400-879-1999
        你所在位置: 首頁 >> 新聞中心 > 行業資訊

        行業資訊

        攪拌車在行駛中要“五注意”

        作者:http://www.www.boy7up.cn 時間:2022-01-08

        1、拐彎的時候一定要慢。
        1. Be sure to turn slowly.
        攪拌車重心高,易側翻!入彎之前提前減速減擋,盡量別拐彎的時候踩剎車。隨時通過后視鏡注意觀察罐子是否在轉,把轉速盡量調慢,轉速過高,車輛容易擺動。
        The mixer truck has a high center of gravity and is easy to roll over! Decelerate and downshift in advance before turning, and try not to step on the brake when turning. Observe whether the can is rotating through the rearview mirror at any time. Slow down the speed as much as possible. If the speed is too high, the vehicle is easy to swing.
        傾斜角大的路段停下罐,滿載料時走到傾斜角度大的路段,先把罐停住。攪拌車本來重心就高,停止罐體的轉動有利于保持車輛的平穩性。
        Stop the tank at the section with large inclination angle. When fully loaded, go to the section with large inclination angle and stop the tank first. The center of gravity of the mixer truck is high. Stopping the rotation of the tank is conducive to maintaining the stability of the vehicle.
        2、爛路用合適的低速擋通過。
        2. Use appropriate low gear to pass through the rotten road.
        遇到路面不平,坑坑洼洼地方用合適的低速擋通過,保證車隨時有爆發力。木板,尖石子一定要避讓,尤其重車!
        In case of uneven road surface and potholes, use appropriate low-speed gear to ensure that the car has explosive power at any time. Boards and sharp stones must be avoided, especially heavy cars!
        自動上料攪拌車
        3、上坡最好是提前減檔。
        3. It is best to downshift in advance when going uphill.
        如果拉得滿的話,注意起步要平緩,上坡更要注意,不能亂減檔,最好提前減檔。而且最大好加快灌子的轉速,已免混凝土流出。
        If it's full, pay attention to a gentle start and pay more attention when going uphill. You can't downshift randomly. It's best to downshift in advance. Moreover, it is best to speed up the speed of pouring and prevent the concrete from flowing out.
        4、下坡切勿重車空擋滑行。
        4. Do not slide with the loaded vehicle in neutral gear downhill.
        長時間行駛或者下坡前都要習慣的測試一下剎車。切勿重車空擋滑行下坡,下坡拐彎時提前減速再減擋再減速,帶擋剎車效果最好。
        Be used to testing the brakes before driving for a long time or going downhill. Do not slide down the slope with the loaded vehicle in neutral. When turning down the slope, slow down in advance, then reduce the gear, and then slow down. The braking effect with gear is the best.
        5、一定要注意限高問題。
        5. Be sure to pay attention to the height limit.
        工地路況復雜,要小心樹木等,特別是要防止刮到電線。
        The road conditions on the construction site are complex. Be careful of trees, especially to prevent scraping wires.
        新聞中心
        聯系我們
        • 公司:萊州聚峰機械有限公司
        • 熱線:400-879-1999
        • 地址:山東省萊州市206國道與308省道交叉口東南50米

        截屏,微信識別二維碼

        国语对白在线视频