對自上料攪拌車的使用，很多人都不去充分的了解相關事項以及有關的問題，所以就會導致不少設備使用過程中出現大的問題。那么今天，對自上料攪拌車的使用這里有建議要給出了。

For the use of self loading mixer, many people do not fully understand the relevant matters and problems, which will lead to major problems in the use of many equipment. So today, there are some suggestions for the use of self loading mixer.

如果自上料攪拌車的液壓泵需要更換，一般不建議自己更換。直接到售后點找專業人員更換，使用的油品需要符合要求，否則會對設備造成很大的損壞，縮短使用壽命。合理標注的液壓油。

If the hydraulic pump from the loading mixer needs to be replaced, it is generally not recommended to replace it yourself. Go directly to the after-sales point to find professionals to replace. The oil used needs to meet the requirements, otherwise it will cause great damage to the equipment and shorten the service life. Reasonably labeled hydraulic oil.

如果油封使用時間長了，油封就會磨損，只需要更換新的油封即可。長期不換油，濾芯質量下降，油液太臟，油封磨損加快，盡快更換液壓油和濾芯。

If the oil seal is used for a long time, the oil seal will be worn. Just replace it with a new one. If the oil is not changed for a long time, the quality of the filter element decreases, the oil is too dirty, and the wear of the oil seal is accelerated. Replace the hydraulic oil and filter element as soon as possible.

傳動軸失去平衡，劇烈振動，造成主軸擺動油封磨損，需及時固定更換軸。液壓油會變質乳化，降低潤滑性能，加速油封磨損。應盡快更換液壓油和濾芯。在嚴重的情況下，需要對系統進行清潔。

The transmission shaft is out of balance and vibrates violently, causing the main shaft to swing and the oil seal is worn. The shaft needs to be fixed and replaced in time. The hydraulic oil will deteriorate and emulsify, reduce the lubrication performance and accelerate the wear of oil seal. Replace the hydraulic oil and filter element as soon as possible. In severe cases, the system needs to be cleaned.

泵支架松動，泵打開，泵固定螺栓松動，造成整個液壓泵振動，油封磨損，經常檢查并排除全自動上料攪拌叉車發生故障的可能，以防萬一并避免失敗。

The pump support is loose, the pump is opened, and the pump fixing bolts are loose, resulting in the vibration of the whole hydraulic pump and the wear of the oil seal. Regularly check and eliminate the possibility of failure of the full-automatic feeding and mixing forklift, just in case and avoid failure.

自動加油/混動一體車系統回油不暢，回油管和散熱器堵塞，造成電機殼內壓力升高，油封漏油。必須清除堵塞物并穩定回油回路。清除散熱器上的障礙物并冷卻系統，以防止泵電機磨損。在嚴重的情況下，必須停止和停止發動機，并用水沖洗泵的電機和散熱器外殼進行冷卻。

The oil return of automatic refueling / hybrid integrated vehicle system is not smooth, and the oil return pipe and radiator are blocked, resulting in the increase of pressure in the motor housing and oil leakage of oil seal. The blockage must be removed and the return circuit stabilized. Remove obstructions from the radiator and cool the system to prevent pump motor wear. In severe cases, the engine must be stopped and stopped, and the motor and radiator housing of the pump must be washed with water for cooling.

冬季運行時，由于預熱不足，油溫過低，油封、油封達不到理想的工作溫度。對策：啟動時停止油箱，怠速運轉10～20分鐘，待油溫恢復正常后更換油箱。

During winter operation, due to insufficient preheating and low oil temperature, the oil seal and oil seal can not reach the ideal working temperature. Countermeasures: stop the oil tank when starting, idle for 10 ~ 20 minutes, and replace the oil tank after the oil temperature returns to normal.

如果散熱器不散熱，油溫會變得過高，粘度和潤滑性會降低，油封會過熱，油封無法工作。自上料攪拌車液壓泵軸端的油封非常脆弱。嚴格遵守相關規定可以有效防止多次漏油。如果您遇到漏油，您需要冷靜下來并確定問題的具體原因。

If the radiator does not dissipate heat, the oil temperature will become too high, the viscosity and lubricity will be reduced, the oil seal will overheat and the oil seal will not work. The oil seal at the shaft end of the hydraulic pump of the loading mixer is very fragile. Strict compliance with relevant regulations can effectively prevent multiple oil spills. If you experience an oil leak, you need to calm down and determine the specific cause of the problem.

對自上料攪拌車的使用這里有建議要給出的相關內容就到這里了，如果您對此有什么疑惑的話，可以先過來我們網站www.www.boy7up.cn看看，咨詢下。

Here are some suggestions on the use of self loading mixer. If you have any doubts about this, you can come to our website www.zkzsljbc See and consult. Com.