If the brake cylinder of the automatic mixer leaks brake fluid or the cylinder pipeline is broken, use iron sheet and copper sheet as a small cushion at the cylinder pipeline joint to block the pipeline, and then tighten the screw, or clamp the fracture flat and curl to block the leakage, so that the wheel can not be used for braking. However, doing so may cause unilateral braking. Pay attention to safety when driving.

自動攪拌車制動總泵缺制動液，可用酒精或白酒代替，特殊情況下可用清水代替。自動攪拌車制動皮碗發漲，將發漲的皮碗放在熱水中浸泡10分鐘-20分鐘，將皮碗上的含油成分去掉，這樣就可以使皮碗恢復原來的尺寸。

The brake fluid of the automatic mixer is replaced by alcohol or baijiu. When the brake cup of the automatic mixer truck rises, soak the rising cup in hot water for 10-20 minutes to remove the oil content on the cup, so that the cup can return to its original size.

自動攪拌車離合器摩擦片燒蝕打滑，對燒蝕不太嚴重的摩擦片，可翻面使用。如燒蝕嚴重，可用棉布或帆布數層（其厚度應與原摩擦片一致），用鋼絲或鐵絲穿過鋼片上的孔，使其固定。駕駛自動攪拌車時應做到起步平穩，換擋動作迅速。

The friction plate of clutch of automatic mixer truck is ablated and skidded. The friction plate with less serious ablation can be turned over for use. If the ablation is serious, several layers of cotton cloth or canvas can be used (its thickness should be consistent with the original friction plate), and steel wire or iron wire can be used to pass through the hole on the steel plate to fix it. When driving the automatic mixer truck, it shall start smoothly and shift quickly.

橫拉桿球節斷損，在保險杠或其它不影響自動攪拌車行駛的地方，卸下一只與球節總長度相似的螺釘，取代斷損的球節，裝上轉向節臂與螺母后，將螺釘露出部分用錘子鉚好。三軸自動攪拌車差速器齒輪損壞，如中、后橋差速器損壞任何一只，都可將該橋傳動軸和半軸拆下，自動攪拌車繼續行駛。若前差速器損壞，可將自動攪拌車輪轂接合盤拆下后繼續行駛。

The tie rod ball joint is broken. In the bumper or other places that do not affect the driving of the automatic mixer, remove a screw similar to the total length of the ball joint to replace the broken ball joint. After installing the steering knuckle arm and nut, rivet the exposed part of the screw with a hammer. If the differential gear of the three axle automatic mixer is damaged, if either the middle and rear axle differential is damaged, the transmission shaft and half shaft of the axle can be removed, and the automatic mixer continues to drive. If the front differential is damaged, remove the hub adapter of the automatic mixing wheel and continue driving.

.自動攪拌車應停入在平地上，并且將鏟斗平放地面。當發動機熄火后，需要反復多次扳動工作裝置操縱手柄，確保各液壓缸都處于無壓休息的狀態。當裝載機只能停在坡道上的時侯，要將輪胎墊牢。不準停在有明火或高溫地區，以防輪胎受熱爆炸，引起事故,先取走電鎖的鑰匙，然后再關閉電源總開關，關閉門窗

. the automatic mixer truck shall stop on a flat ground and place the bucket flat on the ground. After the engine is shut down, the operating handle of the working device needs to be pulled repeatedly to ensure that all hydraulic cylinders are in a state of no pressure rest. When the loader can only stop on the ramp, the tires shall be padded firmly. It is not allowed to stop in areas with open fire or high temperature to prevent accidents caused by tire heating and explosion. First remove the key of the electric lock, then turn off the main power switch and close the doors and windows

以上就是今天小編帶給大家的精彩內容，全自動攪拌車將不斷深化自身的實力，不斷的提高質量，做好價格公正，歡迎大家在網站上點擊購買：http://www.www.boy7up.cn

The above is the wonderful content brought to you by Xiaobian today. The automatic mixer will continue to deepen its strength, continuously improve its quality and do a good job in price justice. You are welcome to click to buy on the website: http://www.www.boy7up.cn