1、首先對于新購入的車輛,初次使用50小時左右,就該檢查各處螺栓緊固情況。包括罐體封頭與減速機的連接螺栓,減速機底座與前臺的連接螺栓,拖輪底座與機架的連接螺栓,以及副梁與大梁的連接螺栓等。以后要保證每月定期檢查一次。
1. First of all, for the newly purchased vehicle, it is necessary to check the bolt tightening condition at all places after the initial use of about 50 hours. It includes the connecting bolts between the tank head and the reducer, the connecting bolts between the reducer base and the front desk, the connecting bolts between the tugboat base and the frame, and the connecting bolts between the auxiliary beam and the main beam. In the future, we should make sure to check it regularly every month.
2、每天行車前檢查托輪與滾道的結合面潤滑油是否干澀,應及時補充,保持良好的潤滑效果。每次在車輛發動之前,檢查冷卻器和減速機的油位,保證油位指示在目視范圍內;檢查液壓油路的密封情況,保持液壓系統清潔和密封,以免塵粒和水份等污染系統液壓油,造成系統不能正常工作或損壞。
2. Before driving every day, check whether the lubricating oil on the joint surface of supporting roller and raceway is dry and astringent. It should be replenished in time to maintain good lubrication effect. Before the vehicle starts each time, check the oil level of the cooler and reducer to ensure that the oil level indication is within the visual range; check the sealing condition of the hydraulic oil circuit, and keep the hydraulic system clean and sealed, so as to prevent dust particles and water from polluting the hydraulic oil of the system, resulting in the system not working normally or damaged.

3、至少每月一次清理托輪和滾道上的污物;通過托輪上的油嘴,向托輪內注入潤滑油脂。保證傳動軸至少每月潤滑一次。
3. Clean the dirt on the roller and raceway at least once a month; inject grease into the roller through the nozzle on the roller. Ensure that the drive shaft is lubricated at least once a month.
4、液壓系統部件精度較高。尤其是攪拌車液壓泵,保養簡易,但要求很高。液壓油要定期更換,首次運行500小時,以后2000小時或至少每年更換一次,濾芯應該同時更換。加油或換油時,發動機必須處于停止狀態,否則將造成液壓系統損壞。
4. The accuracy of hydraulic system components is high. Especially the mixer hydraulic pump, maintenance is simple, but the requirements are very high. The hydraulic oil should be changed regularly. The first operation time is 500 hours, and then 2000 hours or at least once a year. The filter element should be replaced at the same time. When refueling or changing oil, the engine must be in the stop state, otherwise the hydraulic system will be damaged.
With the above summary, I hope to help our customers. If you have any questions or ask for help, please click our website: automatic feeding mixer http://www.www.boy7up.cn Or call consultation, we will try our best to solve it for you